Agilent chemstation launcher
If the system can not reach a target of 2.2-2.3 more then likely there is a leak somewhere. The ratio of the intensity of Mass 28 / Mass 27 is used to adjust the correct pressure in the trap. (See below for complete list of reactions that occur with methane in the source). The system is looking for a target ration of m/z 28 and m/z 27. The methane flow adjument fails and autotune can not be started.īefore the CI autotune is performed, the system will optimize the flow of methane into the source to adjust the pressure to the optimum level. To automate the file transfer, edit your MH GCMS Acquisition Method and add the followingĬommand in the Method Information Post-Run Macro/Command field:
![agilent chemstation launcher agilent chemstation launcher](https://community.agilent.com/resized-image/__size/851x574/__key/communityserver-discussions-components-files/26/2475.image11258.png)
This allows multiple instruments on the same PC to send data to unique locations. masshunter\gcms\x where x=instrument number). Nas_copy.ini, located in the instrument folder (i.e. The configuration information is stored in the file Will allow multiple instruments to share the same drive and store the data in From the command line in MH GCMS Acquisition, type the following:įollow the prompts on the screen to select the destination for data files. !directories have been created, use the ConfigCopy macro to select them for use The configuration process will allow destination selection. The remote file system MUST have directories created for the file transfer before Of exporting data files (and associated directory structure) acquired onĪgilent MassHunter GCMS Acquisition platforms to networked or secondary drives. "nas_copy.mac" is a CONTRIBUTED UTILITY to be used for the purpose
#Agilent chemstation launcher driver#
To setup post run file copy you can use a macro called "nas_copy.mac" to copy the file from the local drive to network driver AFTER the data is collected. The preferred way is to complete this task is to collect the data on the local file system and then copy to the network location after the run completes. Network hardware or software the raw data can be lost. Collecting data to a network drive is usually not a good idea if any issues arise with the Many customer's have the need to collect data directly to a network drive.